Right PressureTyre pressures by registration
Right Pressure › All cars › SEAT › Leon III

SEAT Leon III tyre pressures

Front 29 psi (2 bar), rear 29 psi (2 bar) on the standard 17-inch wheels, and the figures for the other wheel size it was sold with. Manufacturer data, checked cold.

Front
29psi
2 bar
225/45R17
Rear
29psi
2 bar
225/45R17
WheelsTyre sizeFrontRear
17"standard225/45R1729 psi · 2 bar29 psi · 2 bar
18"225/40R1829 psi · 2 bar29 psi · 2 bar
Load/speed rating 91WWheel bolt torque 120 NmPCD 5x112Bolt thread M14x1.5

Manufacturer figures for the SEAT Leon III (facelift), normal load, tyres cold. If the label on your door pillar or fuel flap says something different, go with that.

Resetting the tyre pressure warning light on your SEAT

SEATs use an indirect system that compares wheel speeds through the ABS, so it has to be recalibrated after the pressures are set.

  1. Set all four tyres to the correct cold pressure, with the car parked.
  2. Switch the ignition on.
  3. On the touchscreen, go to Vehicle > Settings > Tyres (on some models Vehicle status > Tyre pressure control).
  4. Press SET. A message, a short flash of the light and a tone confirm it.

Older models

  1. Cars without a touchscreen have a tyre button, either on the centre console or in the glovebox: hold it until it beeps.

When to reset: Recalibrate after any pressure change or wheel change, including swapping front and rear. The system then learns over a longer drive.

Menu names vary by model and year, so check your handbook if yours looks different. More in what the warning light means.

Got a different Leon III? Check by registration

Put your reg in and we'll show the figures for your exact car, including the wheel size it left the factory on.

What tyre pressure should a Leon III have?

29 psi at the front and 29 psi at the rear (2 and 2 bar) on the standard 17-inch wheels, with the tyres cold. Larger optional wheels use slightly different figures — see the table above.

Should I use a higher pressure when the car is loaded?

The manufacturer gives one figure for this car, so no. If you're carrying a full load for a long motorway run, the label on the door pillar may show a higher figure — follow that if it does.

What tyre size does the Leon III use?

225/45R17 or 225/40R18, depending on the wheels it was ordered with. The size is on the tyre's sidewall, e.g. 235/40R18.

Check them cold. Pressures are set for tyres that haven't been driven more than a mile or two. After a run they read 3–4 psi high.

Once a month, and before a long trip. Tyres lose about 1 psi a month on their own.

The sticker wins. If your car's door-pillar or fuel-flap label says something different, go with that — it knows your exact spec.

UK

Pressures sorted. MOT or service due?

Garage List has every independent MOT centre in Great Britain, straight from the DVSA register. Find one near you and call them direct, with no booking fees and nobody in the middle. Some take bookings online too.