Right PressureTyre pressures by registration
Right Pressure › All cars › Austin › Metro

Austin Metro tyre pressures

Front 30 psi (2.1 bar), rear 30 psi (2.1 bar) on the standard 13-inch wheels. Manufacturer data, checked cold.

Front
30psi
2.1 bar
155/65R13
Rear
30psi
2.1 bar
155/65R13
Load/speed rating 73TWheel bolt torque 100 NmPCD 4x101.6Bolt thread 3/8 UNF

Manufacturer figures for the Austin Metro, normal load, tyres cold. If the label on your door pillar or fuel flap says something different, go with that.

Got a different Metro? Check by registration

Put your reg in and we'll show the figures for your exact car, including the wheel size it left the factory on.

What tyre pressure should a Metro have?

30 psi at the front and 30 psi at the rear (2.1 and 2.1 bar) on the standard 13-inch wheels, with the tyres cold.

Should I use a higher pressure when the car is loaded?

The manufacturer gives one figure for this car, so no. If you're carrying a full load for a long motorway run, the label on the door pillar may show a higher figure — follow that if it does.

What tyre size does the Metro use?

155/65R13. The size is on the tyre's sidewall, e.g. 235/40R18.

Check them cold. Pressures are set for tyres that haven't been driven more than a mile or two. After a run they read 3–4 psi high.

Once a month, and before a long trip. Tyres lose about 1 psi a month on their own.

The sticker wins. If your car's door-pillar or fuel-flap label says something different, go with that — it knows your exact spec.

UK

Pressures sorted. MOT or service due?

Garage List has every independent MOT centre in Great Britain, straight from the DVSA register. Find one near you and call them direct, with no booking fees and nobody in the middle. Some take bookings online too.