Right PressureTyre pressures by registration
Right Pressure › All cars › Peugeot › 207 SW

Peugeot 207 SW tyre pressures

Front 35 psi (2.4 bar), rear 35 psi (2.4 bar) on the standard 15-inch wheels, and the figures for the other 3 wheel sizes it was sold with. Manufacturer data, checked cold.

Front
35psi
2.4 bar
185/65R15
Rear
35psi
2.4 bar
185/65R15
WheelsTyre sizeFrontRear
15"standard185/65R1535 psi · 2.4 bar35 psi · 2.4 bar
16"195/55R1635 psi · 2.4 bar35 psi · 2.4 bar
17"205/45R1735 psi · 2.4 bar35 psi · 2.4 bar
16"205/55R1635 psi · 2.4 bar35 psi · 2.4 bar
Load/speed rating 88HWheel bolt torque 90 NmPCD 4x108Bolt thread M12x1.25

Manufacturer figures for the Peugeot 207 SW, normal load, tyres cold. If the label on your door pillar or fuel flap says something different, go with that.

Resetting the tyre pressure warning light on your Peugeot

Most UK Peugeots from about 2013 (208, 2008, 308, 3008, 5008 and current models) use an indirect under-inflation detection system that compares wheel speeds, so it has to be reset after setting the pressures. Some older Peugeots had sensors in the valves.

  1. Set all four tyres to the label pressures, cold, suited to the load.
  2. Switch the ignition on, staying parked.
  3. On the touchscreen, open the Driving (or Vehicle) menu and choose Under-inflation initialisation; on the newest i-Connect screens it's Settings > Vehicle > Safety > Tire Pressure Setup.
  4. Confirm with Yes. A message and a beep confirm it.

Cars without a touchscreen

  1. Press and hold the under-inflation reset button on the dashboard for about 3 seconds until it beeps.
  2. On the Peugeot 108, the button is in the glovebox: press it until the warning lamp flashes 3 times.

When to reset: Reset after every pressure adjustment or wheel change. The warning won't clear by itself.

Menu names vary by model and year, so check your handbook if yours looks different. More in what the warning light means.

Got a different 207 SW? Check by registration

Put your reg in and we'll show the figures for your exact car, including the wheel size it left the factory on.

What tyre pressure should a 207 SW have?

35 psi at the front and 35 psi at the rear (2.4 and 2.4 bar) on the standard 15-inch wheels, with the tyres cold. Larger optional wheels use slightly different figures — see the table above.

Should I use a higher pressure when the car is loaded?

The manufacturer gives one figure for this car, so no. If you're carrying a full load for a long motorway run, the label on the door pillar may show a higher figure — follow that if it does.

What tyre size does the 207 SW use?

185/65R15, 195/55R16, 205/45R17 or 205/55R16, depending on the wheels it was ordered with. The size is on the tyre's sidewall, e.g. 235/40R18.

Check them cold. Pressures are set for tyres that haven't been driven more than a mile or two. After a run they read 3–4 psi high.

Once a month, and before a long trip. Tyres lose about 1 psi a month on their own.

The sticker wins. If your car's door-pillar or fuel-flap label says something different, go with that — it knows your exact spec.

UK

Pressures sorted. MOT or service due?

Garage List has every independent MOT centre in Great Britain, straight from the DVSA register. Find one near you and call them direct, with no booking fees and nobody in the middle. Some take bookings online too.