Right PressureTyre pressures by registration
Right Pressure › All cars › Renault › Grand Scenic

Renault Grand Scenic tyre pressures

Front 32 psi (2.2 bar), rear 32 psi (2.2 bar) on the standard 15-inch wheels, and the figures for the other 2 wheel sizes it was sold with. Manufacturer data, checked cold.

Front
32psi
2.2 bar
195/65R15
Rear
32psi
2.2 bar
195/65R15
WheelsTyre sizeFrontRear
15"standard195/65R1532 psi · 2.2 bar32 psi · 2.2 bar
17"205/55R1733 psi · 2.3 bar35 psi · 2.4 bar
16"205/60R1635 psi · 2.4 bar33 psi · 2.3 bar
Load/speed rating 91TWheel bolt torque 130 NmPCD 5x114.3Bolt thread M12x1.5

Manufacturer figures for the Renault Grand Scenic, normal load, tyres cold. If the label on your door pillar or fuel flap says something different, go with that.

Resetting the tyre pressure warning light on your Renault

It varies by model and version. Many recent Renaults (Clio IV phase 2 and Clio V, Captur II and others) use an indirect tyre pressure loss warning; many from the 2000s and 2010s, and some current ones, have sensors in the valves. Both are reset from the dashboard.

  1. Set all four tyres to the door-edge label pressures, cold.
  2. Switch the ignition on, stopped.
  3. Using the steering-wheel switch, go to the Vehicle tab on the dashboard display and find the tyre pressure reset ('Reset tyre pressure press and hold' or 'Tyre pressure init. long press').
  4. Press and hold OK until 'Operation completed' appears. On cars with a touchscreen it's under Vehicle > Tyre pressure > Reset.

Cars with sensors

  1. On the Vehicle tab, open the Tyre Pressure page and hold the switch for about 3 seconds until 'Learning Tyre Pressures' shows, then drive for a few minutes.

When to reset: Reset after re-inflating, changing pressures, changing or swapping wheels, or using the spare or repair kit.

Menu names vary by model and year, so check your handbook if yours looks different. More in what the warning light means.

Got a different Grand Scenic? Check by registration

Put your reg in and we'll show the figures for your exact car, including the wheel size it left the factory on.

What tyre pressure should a Grand Scenic have?

32 psi at the front and 32 psi at the rear (2.2 and 2.2 bar) on the standard 15-inch wheels, with the tyres cold. Larger optional wheels use slightly different figures — see the table above.

Should I use a higher pressure when the car is loaded?

The manufacturer gives one figure for this car, so no. If you're carrying a full load for a long motorway run, the label on the door pillar may show a higher figure — follow that if it does.

What tyre size does the Grand Scenic use?

195/65R15, 205/55R17 or 205/60R16, depending on the wheels it was ordered with. The size is on the tyre's sidewall, e.g. 235/40R18.

Check them cold. Pressures are set for tyres that haven't been driven more than a mile or two. After a run they read 3–4 psi high.

Once a month, and before a long trip. Tyres lose about 1 psi a month on their own.

The sticker wins. If your car's door-pillar or fuel-flap label says something different, go with that — it knows your exact spec.

UK

Pressures sorted. MOT or service due?

Garage List has every independent MOT centre in Great Britain, straight from the DVSA register. Find one near you and call them direct, with no booking fees and nobody in the middle. Some take bookings online too.